Viking Repair Redmond, WA (425) 585-2373

Redmond, WA · Independent oven workshop

Viking Oven Repair in Redmond — prices first

The service call and the oven bands are printed below, before anything else. A technician measures, names the fault, and gives you one figure inside the band to approve or turn down.

(425) 585-2373 Book online Look up a code
Coverage
Redmond 98052 · 98053
Visits
8:00 am – 8:00 pm, seven days, Redmond only
Phone
(425) 585-2373, 24/7
Diagnosis
$89, taken off the repair
Gas range with the oven door open and a rack set on the floor, one cooktop burner head left uncovered
Visits 8:00 am – 8:00 pm, seven days across Redmond

$89

Service call

Off the bill if you go ahead

$190–$480

Element or thermostat

Bake, broil or the oven thermostat

$180–$440

Igniter

Oven igniter or burner assembly

$430–$650

Control board

Board or touch panel

Prices

Six bands, oven work at the top

Parts and labour together, for Viking repairs in Redmond. Before anyone has measured, a band is the honest answer. After the diagnosis you get one figure for the job, with the band as its guide where one covers the part, and nothing starts until you say yes.

Service call The $89 visit covers the trip and a complete diagnosis; approve the repair and the same $89 is subtracted from its price.

  • Oven thermostat or heating element

    $190–$480

    Bake or broil element, oven sensor or thermostat — the usual end of a temperature complaint.

  • Igniter or burner assembly

    $180–$440

    Oven glow-bar or bake burner, or a sealed burner on the cooktop.

  • Control board or touch panel

    $430–$650

    Only after the sensor and wiring have been ruled out.

  • Dishwasher pump or control

    $200–$390

    Drain and wash pumps, and the dishwasher control.

  • Refrigeration fan or defrost system

    $280–$680

    Evaporator fan, defrost heater and its controls.

  • Compressor or sealed-system repair

    $1,460–$3,210

    The refrigerant side: compressor, leaks, recharge.

Bars share one scale, lowest band to highest

Set any band against the other side of the decision — for this site's own yardstick, a comparable Viking replacement, before installation comes to $7,540–$15,410.

Two screwdrivers, pliers and a wire brush beside a stripped bracket, bushing, bearing washer and grouped screws

Check failed?

Read us the code or the symptom

Viking Repair Redmond, (425) 585-2373. Say what the display or the burner is doing and the model number; the call itself is free. A visit is $89 for the full diagnosis, and it is taken off the repair you approve.

(425) 585-2373 Book online

Redmond oven calls 8:00 am – 8:00 pm, seven days; Viking Repair Redmond picks up 24/7

Code lookup

A code on the display, or a lamp that will not behave

7 fault codes and 17 no-code readings, each with a numbered check. Type the code or a word for what you see.

Symptom checker

No code? Start from the complaint

9 complaints, oven first, each with what the reading tends to show and what usually sits behind it. Filter by appliance; a code on the display belongs in the code lookup above.

  • Oven takes 40 minutes or more to reach 350°F

    On a gas oven with a glow-bar igniter, an igniter drawing under 3.2 amps still glows but opens the gas valve only part way. Self-clean gas models light by spark instead, so the check differs.

    Oven Repair

    Reading Slow climb, nothing on the display

    Book it

  • A code on the display and the oven shuts down

    The same F-number means different things on different Viking controls. On the ones we hold documents for, low codes mostly point at the sensor circuit, the door latch or the cooling fan. Look it up by model before anything is ordered.

    Oven Repair

    Reading Control fault latched

    Book it

  • Bakes burn underneath and stay pale on top

    Dark, glass or oversized pans and foil on the rack cause this more often than a fault. With the pans ruled out, suspect a burner lighting late or a sensor reading wrong.

    Oven Repair

    Reading Heat arriving from below, late in the cycle

    Not urgent

  • Burner clicks and clicks but will not light

    Usually a cap sitting off its seat, a wet electrode or ports glazed with boil-over. The clicking proves the spark circuit is alive; the fault is at the burner.

    Range Repair

    Reading Spark present, no flame

    Book it

  • Simmer flame drops out on the lowest setting

    The low-flame setting is set at the burner valve, and a partly blocked port shrinks it further. Clearing the ports is an owner job; resetting the valve is not.

    Range Repair

    Reading Low flame too small to hold

    Not urgent

  • Fridge at 50°F, freezer still frozen solid

    Points at the fresh-food fan or its defrost circuit rather than the compressor. A freezer that still freezes shows the sealed system is making cold.

    Refrigerator Repair

    Reading Split-cabinet temperature fault

    Act today

  • Water freezing into a sheet under the drawers

    The drain trough has iced over, so defrost melt runs onto the cabinet floor instead of the pan. Worth clearing before it reaches the kitchen floor.

    Refrigerator Repair

    Reading Blocked defrost drain

    Book it

  • Water left in the sump after every cycle

    A jammed drain pump impeller, a stuck check valve or a blocked air gap at the sink. Three cheap causes to rule out before anything expensive.

    Dishwasher Repair

    Reading Drain not clearing

    Act today

  • Dishes gritty, detergent still in the cup

    The spray arms are not turning: a clogged filter starving the circulation pump, or a split arm bearing. Detergent left behind is the giveaway.

    Dishwasher Repair

    Reading No wash pressure

    Not urgent

Repairs

Ovens first, three more beside them

The oven page carries the full checklist and its two price bands. Ranges, built-in refrigeration and dishwashers each have their own page of the faults that bring Viking owners to the phone.

  • 01 Stainless gas range with one sealed burner opened up to expose the igniter, oven door down and rack drawn out Range Repair

    Sealed-burner, griddle and dual-fuel range diagnostics for Viking pro-style ranges across Redmond.

    • Burner clicks continuously but never lights
    • Simmer burner will not hold a low flame and keeps dropping out
    • Griddle plate runs hot on one end and cold on the other
    Open the range repair page
  • 02 Undercounter refrigerator open with the evaporator coil and fan housing exposed at the top of the empty liner Refrigerator Repair

    Built-in and professional-series Viking refrigeration: cooling loss, defrost faults and ice production.

    • Fresh food compartment sitting around 50°F while the freezer is still hard-frozen
    • Compressor runs non-stop and the cabinet never reaches setpoint
    • Water pooling under the crisper drawers and freezing into a sheet
    Open the refrigerator repair page
  • 03 Empty oven cavity with the door lowered, a burner cap and a combination wrench resting on the counter alongside Oven Repair

    Convection, bake and broil element repair plus thermostat and control calibration on Viking ovens.

    • Oven takes over 40 minutes to reach 350°F, or never gets there
    • Display shows an F-code and the oven locks itself out
    • Convection fan rattles, or goes quiet halfway through a bake
    Open the oven repair page
  • 04 Dishwasher drawn right out of its cabinet on the floor, motor, pump and hoses visible under the insulated tub Dishwasher Repair

    Viking panel-ready and integrated dishwashers that will not drain, spray, heat the water or latch the door.

    • Water still sitting in the sump when every cycle ends
    • Dishes come out gritty with detergent still in the dispenser
    • Door latch will not catch so the cycle never starts
    Open the dishwasher repair page

How a call runs

Three steps, no surprises in between

The whole point of measuring first is that nobody gets a bill for a part that was never the problem.

  1. Panel-ready undercounter refrigerator standing open, empty white liner with its cold-air vent and shelf rails

    01

    Tell us the model and the symptom

    The model and serial plate (your use-and-care guide shows where it sits) plus what the appliance is doing narrows the fault list before anyone drives over.

  2. Built-in dishwasher slid forward with its outer panel removed, circulation pump, drain hose and fill line exposed

    02

    Measured at the appliance

    Igniter current, sensor resistance, gas pressure, temperatures over a full cycle. You are shown the reading and told what it means.

  3. Screwdrivers, pliers and a brush with a hinge bracket, bearing race, bushing and sorted nuts, bolts and washers

    03

    One agreed price, then the work

    Parts and labour come to one figure before a panel comes off. When a repair would cost more than the oven is worth, that is said out loud as well.

Reviews · Redmond

What Redmond customers report back

  1. Oven door would not latch for cleaning and the display kept complaining about it. The latch motor cam had worn flat. New latch assembly plus a door alignment, sorted on the first visit.

    Ilona B.Overlake

  2. Water was leaking onto the hardwood from under the door. The lower seal had hardened and pulled away at one corner. Replaced, and no drips since.

    Harriet O.Redmond Ridge

  3. Faint smell of gas near the back of the cooktop. He pressure tested the manifold, found a weeping fitting behind the kick panel and replaced it that afternoon. Glad it was caught early.

    Rina H.Downtown Redmond

Short answers

Asked at the oven door

The questions owners type while the oven is on: is it preheated, why is that lamp still lit, why will the door not open. One page each, answered in the first lines.

Every short answer

  1. How do you know when a Viking oven is preheated?On ovens with an indicator light it goes out at the set temperature; a thermometer confirms it
  2. What does the Viking preheat indicator light mean?The indicator light follows the thermostat: lit while heating, out once the oven is there
  3. What do you do when the oven door is locked shut?Wait for the oven to cool fully after self-clean; if it stays locked when cold, call
  4. When does a slow Viking preheat mean a fault?A gas oven that takes far longer than it used to, or stalls short, usually has a weak igniter
  5. What does the $89 service call cover?The $89 visit pays for the trip and the full diagnosis, and comes off the repair you approve

Coverage

Six districts, one city

This workshop stays inside Redmond. Every district page carries the same numbered check before the visit and the same printed price bands; where a district has something of its own, such as the county permits on Redmond Ridge, its page says so.

Questions

The things people ask before they book

If yours is not here, ask it on the phone. The line is answered 24/7 for booking; visits run 8:00 am – 8:00 pm, seven days.

How soon can a technician get to a Viking in Redmond?

Ring Viking Repair Redmond on (425) 585-2373, answered 24/7, and take the first opening on the calendar; the booking page lists the same openings. Redmond visits run 8:00 am – 8:00 pm, seven days. Nobody quotes an arrival time that earlier jobs could push back.

Which Viking appliances do you repair?

Four families: pro-style gas and dual-fuel ranges, wall and range ovens, built-in refrigeration and panel-ready dishwashers. Ovens are this workshop’s specialty, from codes and preheat faults to igniters, elements, calibration and self-clean failures, and each of those has its own reference page.

My Viking oven shows an F-code. Is the control board finished?

It is rarely the first answer. On the Viking controls we hold service documents for, the low F-numbers mostly point at the oven sensor circuit, and on some electric models at the door latch or the cooling fan. The page for your code says which, and what to check first.

What does the $89 service call cover?

Everything short of the repair itself: the trip, the reading, the cause and one firm parts-and-labour price. Viking Repair Redmond orders nothing and opens nothing until you agree, and when you do, the $89 comes off the repair bill in full.

Can I run a check myself before booking?

Yes, and most of our reference pages open with one: a rack thermometer, the breaker, a setting, the door seal. We stop owners short of anything behind a panel, on the gas supply or on live wiring. When a check fails, call Viking Repair Redmond on (425) 585-2373.

Is Viking Repair Redmond an authorized Viking service center?

No. This is an independent repair business with no affiliation to Viking Range, LLC, and nothing on this site should suggest one. We work on Viking equipment, fit factory-spec parts, and say plainly when a repair is not worth paying for.